Generator Master Built-in
The Generator Master Built-In is provided with a supplied wall support for the electric charge and a plate for being installed in the electrical junction box.
The device can be configured by the Control Unit to:
- provide the signal for the ignition or shutting down of the heat generator;
- provide the signal to control the setpoint for the heat generator operation (only for requiring boilers);
The details for the connection to the electricity grid are on the leafet.
| Generator Master Built-in | |
|---|---|
| Power supply | 230V - 50-60Hz |
| Display | Led |
| Output | Relay 5A 250 Vac |
| Transmission frequency (carrier) | 868Mhz < 10mW |
| Electric protection | Class II |
| Protection degree | IP 20 |
| Dimensions: | 87x87x52 mm |
| Operating temperature range | 0 °C ÷ +40 °C |
| Storage temperature range | -10 °C ÷ +50 °C |
| Reference Standards | EN 60730-1: 2013, EN 61000-6-1: 2007, EN61000-6-3: 2007, EN 61000-4-2: 2009, |
| EN300220-1/2, EN 301489-1/3, R&TTE1999/5/EC, LVD 2006/95/EC, RoHS 2011/65/EU | |
NOTE:
The Generator Master has to be installed at least 500 mm from the Control Unit.
The Generator Master is a on/off relay controlled by the Control Unit, but it does not replace for the remote control panel of the heat generator.
For a correct operation of the heat generator, work strictly from the Instruction Manual.