Pause
The "Pause" mode is a feature of the system that affects all the rooms and the installed devices.
With "Pause", the whole system will be programmed at the desired setpoint.
This way, the system keeps being enabled and programmed by sparing useless waste.
It is possible to either choose the setup until it is turned off, or to program it for a pre-determined time.
NOTE: The "Pause" mode stops every pre-set programming.
On the Home screen, click the bottom right key
.
To modify the "Pause" setpoint, press
.
To set the desired value, use key
and 
.
• To delete and keep the previous setpoint, press
• To confirm the new setpoint, press
.
To enable the "Pause" and keep it on until turned off, press "YES"
.
The mode enabled will be displayed in the middle of the Home screen with key
.
The key will be on display in all the coloured boxes of the system rooms.
.
To disable or modify the function, press the bottom left key
in the Home screen.
It is possible to modify the "Pause" setpoint any minute by
, as in before.
To disable the "Pause", press the button "Disable Pause"
.
To program the "Pause" for a settable period, press "From..To.."
.
To set the desired value, use key
and 
to scroll the fields and use key and .
Confirm by clicking
.
To delete the setting and go back to the previous page, press
.
When the "Pause" is programmed, the item "PROG:" and
are on display.
When the mode is enabled, the key
is on display in the middle of the screen.
To disable or modify the function, press the bottom left key
in the Home screen.
The previous saved programming is on display in the middle of the screen.
It is possible to modify the "Pause" setpoint any minute by
, as in before.
To change the saved programming, press "Modify"
and follow the instructions as in before.
To delete the saved programming, press the button "Delete"
.